Stm32 nucleo programming8/15/2023 ![]() ![]() This application works as expected when compiled and uploaded using the Arduino IDE v 1.88. The code I am uploading is a simple blink program. If someone can direct me to where I can read up on how to get the output from the Arduino IDE then I will be happy to include that here as well. If anyone that has solved this can point me in the right direction, I would certainly appreciate it! I want to use VSCODE for ALL my work, and will be happy to put the Arduino IDE behind me. I have researched that also, but only today. I will humbly admit that there is a lot I have not looked at and tried, because I do not know where I can find a log of the upload handshake from the Arduino IDE, or what command line parameters to use with the CLI version. I have not tried to upload the firmware using the ST-LINK Utility CLI or the GUI because I do not know how. I can also successfully communicate with the board using the ST-LINK Utility v4.0.0. Again, it works with other methods, just not VSCODE/PLATFORMIO.Īlthough I can successfully upload to my STM32F103C8 (128k) blue pill clone boards using Arduino IDE v1.88, I cannot using Platformio on VSCODE. I shortened them to 3 inches and still have the same issue. I read another thread here where the OP had very similar issues to mine and they marked it solved based on wire length, but that is not the issue here. I am using 4 lines (3.3v, gnd, SWO, and SWCLK). I am connected to a clone bluepill STM32F103C8 board with 128k using the attached STLINK SWD interface on a Nucleo F411RE development board. I have read through so many threads over the last few weeks and have still not been able to resolve this issue. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |